How does the gas booster pump work and maintain? Only by fully understanding it before use, can more problems be avoided. Here's a brief introduction.
How the gas booster pump works
The operating principle of the gas booster pump is similar to that of the pressure booster, which applies a very low pressure to the large diameter air driven piston. When this pressure acts on a small area piston, a high pressure occurs. The booster pump can realize continuous operation through a two position five air control reversing valve. The high-pressure plunger controlled by the check valve continuously discharges the liquid.
The outlet pressure of booster pump is related to the air driving pressure. When the pressure between the drive part and the output liquid part reaches balance, the booster pump will stop running and no longer consume air. When the output pressure drops or the air drive pressure increases, the booster pump will start and run actively until the pressure balance is reached again
The single air control non-equilibrium gas distribution valve is selected to realize the active reciprocating motion of the pump, and the gas drive part of the pump body is made of aluminum alloy. Carbon steel or stainless steel shall be selected for the liquid connection part according to different media. The full set of seals of the pump are imported high-quality products, which ensure the performance of the gas booster pump. The gas booster pump B series is a two-stage booster pump, which can increase the low pressure gas to a very high pressure.
Driving air pressure ≤ 7bar, which can be increased to 640Mpa The reversing method of this series of pumps is the same as that of G series. Compared with G series, it can produce twice the output pressure under the same air driving pressure. The whole pump is made of aluminum alloy and stainless steel. In the gas drive part of the pump, smooth gas is required for this series to make the seal and other internal parts smooth. The driving piston diameter of this series of pumps is 160mm
How to maintain the gas booster pump
In the process of equipment selection and use, we should be able to understand these specific installation conditions, or maintenance and operation problems. After all, many equipment has high installation costs, so when carrying out repair and maintenance, or in actual operation, we must be able to operate and set in strict accordance with the operation process and some specific aspects, Only in this way can the performance of these devices be adequately protected
In the process of maintenance and use of the gas booster pump, the principle of the equipment and some specific situations are very critical. We should be able to understand these problems in the process of use. Therefore, operators should follow the process and pay attention to some of their buttons or the principle of each working part.
Many professionals are able to handle these problems well after learning and training. Therefore, when choosing to use these equipment, we must take these conditions into account. Maintenance and repair are very critical and necessary, which is conducive to extending its service life.
In addition, in the process of operation, they should also be determined according to some use methods or specific related problems, and some information and conditions of connecting pipelines are very critical and necessary. More precautions for using the device can be found on our website http://www.madaboutmermaids.com/ Detailed consultation.